Recent Posts
Step 1: Extend the solder wick out of the reel and ensure there's no solder already on the end. If there is any solder already wicked onto the end. Just use a pair of side cutters to snip the...
Sometimes after removing a componant a lot of excess solder can be left remaing on the PCB. The problem is not all of us have the nessesary desoldering tools to had to make the job easier. One of the...
https://youtu.be/UUz0zzGdqII Oscilloscopes are primarily set up to measure the voltage of an electrical signal, which is then graphically represented by waveforms. However, scopes can be used to...
https://youtu.be/xty1G5UBYb0 A solder pad is the part of a printed circuit board — or PCB — that supports the pins of components like transistors and chips. Typically, when devices break or...
older paste is the bond that holds modern consumer electronics together. It secures surface mount electronic components to circuit boards, all while providing electrical and thermal connections. If...